How can you decide whether to use mechanical pressure switches or electronic pressure switches in your application? Each kind of pressure switch has individual advantages, but additionally its limitations. The primary differences in functionality between mechanical and electronic pressure switches are the way the applied pressure can be used to use the switch, the kind of switch technology, and how the switch point can be adjusted.
Functionality of mechanical pressure switches
A mechanical pressure switch converts the pressure of a fluid into a mechanical movement that actuates the mechanical switch contact in the pressure switch. Tank has either a preset or an individually, mechanically adjustable switch point. Hate and every time the switch is actuated, a mechanical pressure switch sends a power switching signal, but will not need a voltage supply.
Ordinarily, mechanical pressure switches are simple devices that are either designed for cost-effective applications or optimised for long-term use, depending on how often the switching signal should be transmitted. The switches are thus designed either for a low application rate (very few switching cycles e.g. in safety applications) or for a higher application rate (frequent switching changes e.g. in process control). Played is normally not adjustable, thus the reset point for switching cannot be configured and is preset by factory setup.
Mechanical pressure switches are often used to switch high currents, such as pumps and drives. However, mechanical contacts often have problems switching the low voltages in PLCs and modern electronics, unless expensive, gold-plated switch contacts are used.
Functionality of electronic pressure switches
An electronic pressure switch generates electronic switching signals and, frequently, also an additional, analogue output signal proportional to the pressure. They are either programmed at the factory to the required switch points or they feature a programming interface with integrated display and buttons.
Electronic pressure switches have integrated, programmable logic. This enables the switch points and the output signal to be adapted to the application-specific needs. Delay time, switch point, reset switch point, hysteresis or window function, normally closed or normally open, and much more functions can be programmed in modern electronic pressure switches.
The local display of an electronic pressure switch also offers a continuous pressure indication and shows if the switch outputs are active or not. Finally, modern technologies, including the usage of IO-Link, enable programming remotely via signal cables.
Note
More info on mechanical pressure switches and electronic pressure switches can be found on the WIKA website.
Also read our articles
Mechanical vs electronic pressure switches: Application areas
Mechanical pressure switches: How does one set the switch point?
Pressure switches in booster pumps

Leave a Reply